[Guide] Beginners Guide On Using SP Flash Tool

Today I am going to show you how to use SP Flash tool. There are many users who do not know how to use SP Flash Tool even though it is a really easy tool to use. 
This is going to be a very short and easy guide. Using this guide you will be able to flash any firmware in your MTK device.

Disclaimer : Always check that the firmware is made for your device, if you flash firmware which is not made for your device you will Hard Brick your device.

This guide shall not be re-shared or re-posted anywhere else.

Things You Need :
1. Proper Device Drivers : Download
2. Proper MTK VCOM Drivers Installed
3. A PC
4. SP Flash Tool : Download

How To :
- Download And Install The Universal Device Drivers From The Things You Need Section
- Find and Install The VCOM Drivers
- Download SP Flash Tool
- Download The Firmware you need to flash (SP Flash Tool Firmware, Not a Recoevery Flashable ZIP)
- Unzip SP Flash Tool
- Unzip the SP Flash Tool ZIP
- Run SP Flash Tool as an Administrator
- Load the scatter File

- After You have Loaded the scatter file. Turn off your phone.
- Unplug the USB from the device
- Click on download in SP Flash Tool
- Without Turning ON your phone connect it to your PC
- Let the Process begin and wait till there is a Green Circle Saying Process Completed
- Now Remove the battery again and place it in
- Turn ON your phone

Whola You have successfully flashed a firmware using SP Flash Tool.

[Guide] Beginners Guide On Using SP Flash Tool [Guide] Beginners Guide On Using SP Flash Tool Reviewed by MTK Hacker Pro on 4:12 PM Rating: 5

No comments:

Powered by Blogger.